Home     Electronic Store     Electronic Blog     Electronic Schematics     Tutorials     Downloads     Contact

Most accurate and simplest LC inductance / capacitance Meter that you will find. It allows you to measure incredibly small inductances starting from 10nH to 1000nH, 1uH to 1000uH, 1mH to 100mH and capacitance from 0.1pF up to 900nF. The circuit uses an auto ranging system so that way you do not need to spend time to select the ranges manually.

AVR – ISP programmer for STK200 and for PonyProg.

This AVR ISP original by ATMEL you can found on "AVR software and technical Library - April 2003" CD-rom.It small component count I design new PCB and change some component that easy to build small PCB .The new firmware was writen by John Samperi for AT90S2313. This code can program more devices.

This simple AVR Programmer will allow you to painlessly transfer hex program to most ATMEL AVR microcontrollers without sacrificing your budget and time. It is more reliable than most other simple AVR programmers available out there and can be built in very short amount of time.

I needed to replace two old, unreliable thermostats for controlling the heating and cooling for a large garden shed. Commercial basic digital thermostats are available quite cheaply, but some lack the ability to control heavy loads or have the extra features that I require for saving energy when the door is often left open or to indicate temperature being out of range etc. I like the PIC18F1320 microcontroller used in my previous project - so decided to use it again in a very similar design to drive three multiplexed LED displays and read the temperature from a Dallas/Maxim DS18x20 "1-Wire" digital sensor.

Dual PIC Temperature meter that allows to measure temperature in two different locations at the same time. Never before such a useful and powerful circuit could be built with so little components and yet provide endless possibilities. This is all possible thanks to the use of PIC16F628 microcontroller and 2x16 character LCD display that act like a small computer which can be customizable thanks to upgradeable hex firmware.

Higher voltage can be measured with resistor voltage divider

This project describes a very powerful frequency counter. Very simple construction which everyone can build. 6 LED display will present the frequency with 1kHz resolution and RS232 communication to computer is available as option. The software has also been implemented with some smart functions, for calculating frequencies in receivers where IF is 455kHz or 10.7MHz. I present schematic, PCB, components and window software.

This is simple 3-digits digital volt meter.PIC16F676 used to read analog signal(voltage) and display the value on 3-digits 7-segment. You can apply similar principles to measure DC current with parallel R shunt.

On this page, I will introduce the Count-down timer with PIC16F84A. I am putting a count-down timer by the hardware on Electronic Circuits Application Garage. The function of the timer is the same as it approximately. (The stop switch is added) Because this unit was made compactly, the wiring of the back becomes quite complicated.