A very good and powerful Regulated Power Supply section was implemented by simply adding a PNP power transistor to the excellent LM317T adjustable regulator chip. In this way this circuit was able to deliver much more than the power required to drive two Mini-MosFet amplifiers to full output (at least 2Amp @ 40V into 4 Ohm load) without any appreciable effort.
R1_______________3R9 1 or 2W Resistor
R2______________22R 1/4W Resistor
R3_______________6K8 1/4W Resistor
R4_____________220R 1/4W Resistor
R5_______________4K7 1/2W Resistor
C1____________3300µF 50V Electrolytic Capacitor (or 4700µF 50V)
C2,C5__________100nF 63V Polyester Capacitors
C3______________10µF 63V Electrolytic Capacitor
C4_____________220µF 50V Electrolytic Capacitor
D1_____Diode bridge 100V 4A
D2___________1N4002 200V 1A Diode
D3______________LED Any type and color
IC1___________LM317T 3-Terminal Adjustable Regulator
Q1____________TIP42A 60V 6A PNP Transistor
SW2_____________SPST Mains switch
T1_____________230V Primary, 35-36V (Center-tapped) Secondary,
50-75VA Mains transformer (See Notes)
PL1____________Male Mains plug with cord
