19 KHz MPX Low Pass Filter
19 KHz MPX Low Pass Filter


  19 KHz MPX Low Pass Filter

This map, armored also enables automatic MONO / MPX through a low-pass filter, even with a multiplex on its entry by using an ON / ON, panning, the whole spectrum MPX more RDS is sent to the synthesizer, on the other hand when it is in a position MONO, the low-pass filter is activated and share its cutoff frequency at 15 KHz, only modulation G + D is sent to the synthesizer, as 19 KHz. 19 KHz carrier, the signal multiplex and subcarrier 57 KHz is thereby eliminated, which provides ease of use for example in a string of issue relay tuner, if the link between the issuer Departure and receiver re-issue was not of good quality stereo, you sufficient to switch to mono to improve sound quality, you can then connect the RDS encoder at the re-issuer.


19 KHz MPX Low Pass Filter



19 KHz MPX Low Pass Filter


19 KHz MPX Low Pass Filter


19 KHz MPX Low Pass Filter


Downloads

Project documentation

HEX Program
 19 KHz MPX Low Pass Filter - Link


 

Build your own LC Meter and start making your own coils and inductors. This LC Meter allows to measure incredibly small inductances making it perfect tool for making all types of RF coils. LC Meter can measure inductances starting from 10nH - 1000nH, 1uH - 1000uH, 1mH - 100mH and capacitances from 0.1pF up to 900nF. The circuit includes an auto ranging and "Zero Out" function to make sure the readings are as accurate as possible ... [more]


Electronics-DIY.com © 2002-2010. All Rights Reserved.