I was fascinated by the Patek - which is also based on the LM3875 opamp chip. It is small, very elegant and with an external power supply.

I hate working in tight spaces but I am pretty good at it. Everything about this amplifier build was difficult due to the space restrictions. With many nights of pre-design trials I finally brought it all together.

A look at the images reveals just how small this amp is. The box size is 119 X 94 X 34 mm. It sits in the palm of your hand and has two volume attenuators, oversize solid brass isolation feet with pads, gold plated heavy duty speaker terminals, gold plated input jacks, pure silver (99.99%) wiring on the signal path, 5600uF filtering capacitors and heavy duty copper wiring to the speaker terminals.

All wiring is similar to thispoint-to-point LM3875 gainclone using a breadboard. The chips are bolted to the sides of the case so cooling is not optimal. The amplifier is fitted with an RSR232 plug to receive power from the remote supply. The umbilical cord is heavy duty with two of the four wires supplying earth. A ferrite choke on the end of the power cord is used to reduce any stray EMI from going into the amp. The amplifier can be sat on the die cast case of the PS which sits on thick silicon feet.

EXTERNAL POWER SUPPLY

Power is supplied via an external power supply. An EMI filter is used to clean up the AC and the enclosure is a heavy Aluminum Die cast case. The power supply transformer is toriodal (160VA) and a high current bridge rectifier produces +/-35V. Two 4.7uF polyester capacitors are used to pre-filter the supply rails.

GAINCLONE SOUND

Good strong and clean sound. Not in the same class as the monoblocks but extremely listenable. I use it as my family room amp driving two 63L 12" woofer based 3-way system. It drives these speakers easily and loud if required. I have tested my monoblocks to 400kHz and there is no reason why The Nanoo should not have the same frequency range.